Loading...
Serving Fontana, CA and surrounding areas. (909) 775-1547
Fontana's punishing sun and heat break down asphalt faster than almost anywhere in California. Regular sealcoating keeps your driveway or parking lot sealed against UV, water, and vehicle fluids - before small problems become expensive repairs.
Asphalt sealcoating in Fontana, CA is a thin protective layer applied over your existing pavement - it shields the surface from UV oxidation, water intrusion, and vehicle fluids, and most residential driveways are completed in a single day. Think of it as sunscreen for your pavement, not a structural repair.
In the Inland Empire, asphalt binder breaks down faster than almost anywhere else in California. Summer temperatures regularly exceed 100 degrees, and UV radiation is relentless. An unsealed driveway turns gray, becomes brittle, and starts cracking years before it should. Staying on a sealing schedule every two to three years is the most cost-effective way to avoid a much more expensive repaving job.
Sealcoating does not fix large cracks or structural damage - those need to be addressed first. If your pavement has significant cracking, consider pairing a sealcoat with our asphalt crack sealing service to handle both in one visit.
Fresh asphalt is deep black. When it fades to gray, the binder is oxidizing and the surface is becoming brittle. In Fontana's intense sun this fading happens faster than homeowners expect, and once the surface is brittle, cracks follow quickly.
Hairline and surface cracks are the early warning that pavement is drying out. Left alone, winter rains push water in, the soil shifts, and small cracks become large ones. Catching them now means a sealcoat with crack filling rather than a full repair job.
When sealer is intact, fluids bead up on the surface. When it has worn away, oil and fluid stains soak in and weaken the asphalt beneath. If stains are absorbing rather than sitting on top, your surface protection is gone.
Even if your driveway looks fine, the Inland Empire's sun and heat accelerate wear on the protective layer. If it has been three or more years - or you are not sure when it was last done - a quick visual check by a contractor is a smart step.
We handle sealcoating for residential driveways, commercial parking lots, and everything in between. Every job starts with thorough surface cleaning, crack filling, and edge masking before a single drop of sealer goes down. We apply one or two coats depending on your surface condition and what the job calls for. If your lot also needs fresh markings after sealing, we can pair the work with our parking lot striping service so everything is done in one visit.
We use traffic-grade sealer products designed for the Inland Empire's high-UV environment. Cheap, watered-down sealer looks fine on day one and peels by the end of the season. We do not cut corners on the product or the prep - both matter equally for a job that holds up through Fontana's summers.
Best for homeowners with asphalt driveways showing fading, minor cracking, or surface oxidation.
Ideal for business owners and property managers who need a lot sealed with minimal downtime.
For surfaces in poor condition that need an extra coat to rebuild protection and uniformity.
Fontana sits in the Inland Empire, where summer highs regularly exceed 100 degrees and UV radiation is intense year-round. That combination bakes out the asphalt binder faster than in coastal California, turning driveways gray and brittle well before they should fail. A lot of homes in Fontana were built in the 1990s and early 2000s - and after 20 or 30 years of Inland Empire heat, concrete and asphalt flatwork is starting to show it. Staying on a sealing schedule is the most practical way to extend what you have without starting over. For homeowners in Fontana and Rialto, the climate case for regular sealcoating is especially strong.
Fall is the best time to seal in this area. Temperatures drop from summer highs, the surface is dry, and you get a waterproof barrier in place before the winter rainy season. When Fontana gets a heavy rain after a long dry spell, water runs fast - and unsealed cracks are exactly where it goes. Fontana's clay-bearing soils also expand and shrink with seasonal moisture changes, putting stress on pavement from below. Keeping cracks sealed prevents water from widening them when the ground shifts.
For guidance on asphalt best practices, the National Asphalt Pavement Association publishes current industry standards and maintenance recommendations.
We respond within 1 business day. A contractor comes to your property, assesses the surface condition, measures the area, and spots any cracks that need filling before sealing. You get a written quote - not a phone guess.
The crew power-washes, blows off debris, fills cracks with flexible filler, and lets everything dry completely. This prep is the most important part. Sealer applied over a dirty or damp surface peels within months.
We mask edges, apply sealer with squeegees, brushes, or a spray system depending on your surface, and let each coat set before the next goes down. Most residential driveways are done in a few hours.
We walk the driveway with you before leaving. Check edges are clean, no pooling in low spots, and all cracks were filled. Stay off the surface for 24 hours on foot and 48 to 72 hours by car. Keep sprinklers off during this window.
We respond within 1 business day. Getting an estimate is free and puts you under no obligation. Once you submit the form, someone from our office will call you to schedule a free on-site visit so we can assess your surface and give you an accurate written quote.
(909) 775-1547We come to your property, walk the surface, and give you a written quote that breaks out prep, crack filling, and coats. You know exactly what you are paying for before work starts.
Fontana's summer heat and UV intensity affect when and how sealer is applied. We schedule around the weather - early morning in peak summer, fall timing before winter rains - so the product bonds correctly and lasts.
Our license is verifiable through the California Contractors State License Board at cslb.ca.gov. We carry liability insurance and workers compensation on every job - ask for proof before any contractor starts work on your property.
We power-wash, fill cracks, and let the surface dry completely before applying a single coat. This is what separates a job that lasts years from one that peels in a season.
Every sealcoating job we do in Fontana starts with a proper inspection and thorough prep. We have worked across the Inland Empire long enough to know that skipping steps to save time produces jobs that look bad within a season. We would rather do it right once than come back and fix it.
Keep your lot organized and compliant with fresh, clearly painted stall lines, arrows, and accessible space markings.
Learn MoreFill active cracks with flexible sealant before they widen into costly structural damage.
Learn MoreFall and spring slots fill fast - lock in your date before the next rainy season or summer heat wave arrives.