Loading...
Serving Fontana, CA and surrounding areas. (909) 775-1547
Your driveway or lot does not have to be torn out to look and perform like new. A properly laid resurfacing job over a solid base gives you years of use at a fraction of full replacement cost.
Your driveway or lot does not have to be torn out to look and perform like new. A properly laid resurfacing job over a solid base gives you years of use at a fraction of full replacement cost.
Asphalt resurfacing in Fontana means bonding a fresh layer of new asphalt over your existing surface, skipping the tear-out entirely - most residential driveways are completed in a single day, with the surface ready for light use within 24 to 48 hours.
It is one of the most practical options available when your driveway or parking area has widespread surface cracking, fading, or roughness, but the base underneath is still solid. In Fontana, where UV and heat oxidize unprotected asphalt faster than almost anywhere else in California, a lot of surfaces reach this point earlier than owners expect.
If the surface has already developed isolated failures, our pothole repair service can address those spots before or alongside a full resurfacing. For surfaces where the base has shifted or crumbled, we will recommend a different approach and explain why.
Fresh asphalt is dark and slightly flexible. When it turns light gray and feels hard and gritty underfoot, the oils have been baked out by sun and heat. In Fontana's climate, oxidation happens faster than most places, and a brittle surface cracks much more readily under traffic.
Small hairline cracks are normal as asphalt ages, but when they start connecting across a large area, the surface is near the end of its useful life. Resurfacing at this stage - before the cracks reach the base - is the most cost-effective fix.
Fontana does not get a lot of rain, but standing water in the same spots every time it rains means you have low spots or drainage problems. That water seeps into cracks and weakens the base. Resurfacing with proper grading corrects the drainage and protects the foundation.
Oil drips and fuel spills that have penetrated the surface do not clean away. These stains also soften the surrounding asphalt over time. If the surface looks permanently damaged no matter how much you clean it, a fresh layer is the practical answer.
We handle both residential driveways and commercial parking areas. Before any new asphalt goes down, we inspect the existing base to confirm it can support a resurfacing job. If it cannot, we tell you - resurfacing over a failed base does not last, and recommending work we know will fail early is not something we do. When the base is sound, we apply a bonding tack coat so the new layer adheres properly, then pave and compact with the right equipment for a smooth, even result.
For situations where the existing surface needs to be removed before new pavement can be placed, our asphalt milling service grinds down the old surface precisely without disturbing the base, making it ready for a new layer. After resurfacing, regular sealcoating every few years is the best way to extend the life of the new surface in Fontana's UV-heavy climate.
Ideal for homeowners whose driveways have surface cracking and fading but a base that is still structurally sound.
Suited to parking areas that have weathered beyond routine maintenance and need a complete surface renewal.
Best when isolated potholes or soft spots need to be corrected before the new surface layer is applied.
Right for surfaces where the old asphalt must be removed to meet clearance or grade requirements before fresh paving.
A large share of Fontana's residential neighborhoods were built between the late 1980s and the early 2000s, which means a lot of driveways in the city are now 20 to 35 years old and have lived through decades of Inland Empire summers. The combination of intense UV, triple-digit heat, occasional heavy winter rains, and clay soils that shift with moisture changes takes a steady toll on asphalt surfaces. Many driveways that look like they need complete replacement actually just need a proper resurfacing - the base is still there, but the surface layer has worn out.
Spring and fall are the most popular seasons for resurfacing in the Inland Empire because temperatures are warm enough for proper compaction without the extreme heat of summer. Homeowners and property managers in areas like Redlands, CA and Rancho Cucamonga, CA face the same conditions and the same scheduling demand, so booking in advance during those windows is worth doing.
Contact us by phone or through our online form. We respond within one business day and will schedule a free on-site estimate - the condition of your base has to be seen in person before we can give you an accurate scope.
We check the full area - base condition, existing cracks, drainage, edges, and any grade issues. If the base is compromised, we tell you honestly and explain the options. A written estimate follows covering scope, materials, and timeline.
The crew cleans the surface, repairs significant cracks or soft spots, and applies a tack coat for bonding. Hot-mix asphalt is then laid and compacted with a roller. Most residential driveways are finished in a single day.
We give you a clear timeline - typically 24 to 48 hours before foot traffic, at least a week before vehicle parking. We also outline when a sealer should be applied to protect the new surface from Fontana's UV, giving your investment the best chance of lasting the full expected life.
We will assess your surface in person and give you an honest recommendation - resurfacing or full replacement - with a written quote you can compare.
(909) 775-1547We will not sell you a resurfacing job if the base cannot support it. We check the base condition before quoting and explain what we find. Fontana's clay soils can shift a base over time, and identifying that before work starts saves you from a new surface that fails prematurely.
California requires a valid state contractor's license for paving work. You can confirm any contractor's license through the California State License Board before signing anything. Hiring a licensed contractor also protects you if any issues arise after the job.
Not all hot-mix asphalt is the same. The Asphalt Institute sets material and mix standards for high-temperature applications. We choose mixes appropriate for Fontana's climate so the finished surface stays dense and flexible through the Inland Empire summer instead of softening and rutting.
We schedule work when it fits your routine, confirm the job scope in writing, and give you specific guidance on curing times before we leave. Most residential driveways are back in use within 48 hours - no extended construction zone, no open-ended timeline.
The combination of honest assessment, licensed work, and materials chosen for local conditions is what separates a resurfacing job that lasts a decade from one that starts cracking within a couple of seasons.
Isolated failures and soft spots are corrected before they spread and require more extensive surface work.
Learn MoreWhen the old surface must be removed before new asphalt can be placed, milling removes it precisely without disturbing the base.
Learn MoreSpring and fall slots fill fast in the Inland Empire - lock in your date before the best weather windows are gone.